Journey

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change the X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 2.2mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Grey Transmission Distance: 1 PLA BambuLab Basic White Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Orange Transmission Distance: 5 This print uses 6 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Blue Gray At layer #14 (1.2mm) swap to Grey At layer #21 (1.76mm) swap to White At layer #23 (1.92mm) swap to Yellow At layer #25 (2.08mm) swap to Orange for the rest.