Joy-Con (Pro version) Case

This is my first project. In this case, I have created a version for the Nintendo Switch Pro version joy-cons (or as I call them "big controllers") since I have not seen anything related.

The measurements are very fair (it has currently been printed with an Ender 3 V2 Neo and a 0.4 mm noozle at a speed of 80mm/s, 60ºC bed and 200ºC noozle) and although it has not turned out bad, I have had to reduce the attachment areas a little since The PLA has been deformed by the heat (a few millimeters but enough).

Otherwise it is functional, two controls fit perfectly with the straps.
I will continue working on it.

The measures of this proyect are:

JoyConCaseBase:
- High: 52 mm
- Length: 134 mm
- Width: 60 mm

JoyConCaseTop:
-High: 92 mm
- Length: 134 mm
- Width: 60 mm