Thingiverse
Junction Block
von maleatherwood
3
Downloads
0
Likes
0
Makes
Made for my powerwall to help make cable junctions.
Works with a 5/16" bolt at 1"
scaling up to 1.2 times works with a 3/8" bolt.
I am finding on these prints to make the outer skins at least 3 mm thick with 50% fill works best.
Works with a 5/16" bolt at 1"
scaling up to 1.2 times works with a 3/8" bolt.
I am finding on these prints to make the outer skins at least 3 mm thick with 50% fill works best.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!