K2 Plus Lid Riser

A simple K2 lid riser with closable vents. I couldn't find a riser for the K2 that I like so I set about designing a simple low profile riser. The main reason for this was to stop the PTFE tube at the hotend rubbing on the glass top when it was printing. The riser is a nice tight fit in to the lid of K2 and the glass is also a snug fit You will need to print the following: 4x Corners 2x Front-Rear Vent 2x Side Vent 2x Front-Rear Slide Vents 2x Side Slide Vents Assembly: Connect the Front-Rear Vent and Side Vents to the Corner pieces, then slide the Front-Rear Slide vents inside the Front/Rear vents. Then slide the Side Slide Vents in to the Side Vents. Print recommendations: I recommend printing in ASA or PETG I would suggest a minimum of 10% Gyroid infill 3 Perimeter walls There are 2 versions I have uploaded: K2 Riser: has tight tolerances and may require a little sanding to get it to fit together K2 Riser Loose: has bigger tolerances and may be a little slacker and a bit more forgiving for printer tolerances