K2Plus Ambient Lights For spools

I’m excited to share my proposal for the CFS lighting setup for the Creality K2PLUS. This is a straightforward project that requires basic knowledge of electronics, soldering wires, and drilling the case to mount the USB-C plug.The LED strip can be powered using either a phone charger or the printer’s USB plug (though the latter is not recommended for long-term use). You can also add a presence sensor to the circuit so the LED lights up only when you are near the printer.For mounting the USB-C plug that powers the LED, carefully drill a hole to fit it, then secure it from the inside using the washer provided in the file. Use appropriate cables designed for 5V connections to ensure safety, and make sure the wires are soldered carefully with tin. Leave a bit of extra wire length to allow you to open the CFS cover easily without stretching the cable.If you have any questions or need further assistance, please don’t hesitate to contact me.Important Note: The LED holes are spaced with a pitch of 33.3 mm to fit 5V LEDs. Please double-check compatibility before purchasing.Happyprinting!