K31 Scope Mount

!!!THIS MOUNT IS NOT VERY ACCURATE AND FOR SHOOTING 300 METERS WITH IT YOU WILL NOT HIT GOOD AND HAVE A LOT SPRAY!!!
In general, it is nice to have. But you *will* have more fun with a full metal scope mount. I tested it for 300 meters and I had a spray of about 60 cm on the target.
I think you still have spray due to the deformations of the plastic itself. And from every shot the recoil moves the mount a little bit and your scope isn't centered. You can print a lot of things, but not everything. Even though I had to learn this the hard way it was still very interesting to do and I had a lot of fun designing and testing it. Also it was interesting to see the 300 m target with 24x.

With this scope mount, you can still aim through the iron sight, the ejecton port isn't blocked and it isn't hurting the parts of the K31. The picatinny rail is 20 mm.

Important: Make for the section around the screws of the main part a 100% infill. The holes are 35 mm long. I made the 1x1 cm section