Thingiverse
KBDPad MkII Basic Case
2
Downloads
1
Likes
0
Makes
This case is designed to be held together using four screws in the corners. I used some screws I salvaged from broken nerf guns, 3mm diameter or so, and less than a centimeter long. However, if you have different screws you would like to use, you can just drill the holes out.
When screwing screws into the holes for the first time, twist it in a ways, untwist a little bit, and continue. This greatly reduces the odds of cracking the part.
Enjoy!
When screwing screws into the holes for the first time, twist it in a ways, untwist a little bit, and continue. This greatly reduces the odds of cracking the part.
Enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
