Thingiverse
Knife sharpener
von Malt
28
Downloads
10
Likes
0
Makes
For manufacturing it is necessary
shaft diameter 8 mm long 500 mm - 1 pc.
shaft diameter 8 mm long 300 mm - 1 pc.
bolt m6 x 25 - 5 pcs. nuts m6 - 5 pcs.
bolt m4 x 30 - 3 pcs. nuts m4 - 3 pcs.
the base of the plywood is 10 mm 270 mm x 125 mm.
screw 4 x 16 - 4 pcs.
Teflon tube is about 42 cm. For bearing
You can experiment with the form of the base.
shaft diameter 8 mm long 500 mm - 1 pc.
shaft diameter 8 mm long 300 mm - 1 pc.
bolt m6 x 25 - 5 pcs. nuts m6 - 5 pcs.
bolt m4 x 30 - 3 pcs. nuts m4 - 3 pcs.
the base of the plywood is 10 mm 270 mm x 125 mm.
screw 4 x 16 - 4 pcs.
Teflon tube is about 42 cm. For bearing
You can experiment with the form of the base.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!