Knife Sharpening Guide

Update:　2022/2/2 (five 2!!!)
To make the knife easier to handle, the slider was updated to have a wider top surface.
I recommend you try the wider one first.

You may need to print a mirrored slider to polish the bottom part of the knife,
or just polish the small portion without the slider.

------------------

My whetstone is larger than the original one. The size is 210×70×15mm.
And the print size of my printer is 200x200mm.
So I cut the stopper and shorten the base, and make it wider.


Also, I thought it would be better to tilt the support.
Then, I made this.

The touching angle is16 deg.

I was a little worried about slipping of whetstone, but it did not slip on the base.

I've only used it a few times. It may need some improvements to make it easier to use, but for now it works.