Thingiverse
Music
Go to Model
Knobs for Pocket Operator
13
Downloads
17
Likes
0
Makes
Hi
The potentiometer knobs of the pocket operator are also rather small and difficult to operate, especially if you have thick fingers - like me. ;-)
Since I already made knobs for my KORG monoton Delay, I also made some for my Pocket Operators.
I also tried different designs for the position indicator on these knobs. First without, then with a simple stroke etc., then I thought about using the two small symbols from Teenage Engineering and made different designs with them. Since I still haven't equipped my 3D-Printer with a smaller than 0.4 mm nozzle, a filigree design was again not good to print. So I decided to make the symbols relatively large.
The symbols are embedded deeper and can be filled with a contrasting color or with a color matching the color concept of the respective Pocket Operator. Or the knobs can simply remain as they come out of the printer.
Greetings from Berlin
The potentiometer knobs of the pocket operator are also rather small and difficult to operate, especially if you have thick fingers - like me. ;-)
Since I already made knobs for my KORG monoton Delay, I also made some for my Pocket Operators.
I also tried different designs for the position indicator on these knobs. First without, then with a simple stroke etc., then I thought about using the two small symbols from Teenage Engineering and made different designs with them. Since I still haven't equipped my 3D-Printer with a smaller than 0.4 mm nozzle, a filigree design was again not good to print. So I decided to make the symbols relatively large.
The symbols are embedded deeper and can be filled with a contrasting color or with a color matching the color concept of the respective Pocket Operator. Or the knobs can simply remain as they come out of the printer.
Greetings from Berlin
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
