Thingiverse
Kossel printer side support
door Diablillowilly
2
Downloads
2
Likes
0
Makes
This is a support made to be attached a control board to a 2020 aluminum profile from a delta printer. It has a 30° angle so the board will be flat to the printer sides. I actually use this with my MKS GEN 1 board, but you could use it whith any board.
The design is made to use M4 bolts ,and t a m4 hexagonal nut fitted inside the rectangular hole
.
(Be carefull where you place the board or how big it is since the effector moving around the buildplate could hit it andd break the board)
The design is made to use M4 bolts ,and t a m4 hexagonal nut fitted inside the rectangular hole
.
(Be carefull where you place the board or how big it is since the effector moving around the buildplate could hit it andd break the board)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!