Thingiverse
KTM Insert Case holder
von guido-pdm
1
Downloads
1
Likes
0
Makes
Personally, the back was a little less orange.
The inserts are hammered into the case carrier from below and then carefully fused with the surrounding material with the tip of the soldering iron.
The inserts are hammered into the case carrier from below and then carefully fused with the surrounding material with the tip of the soldering iron.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!