Thingiverse
Lacrosse Trophy
por rianocerous
2
Descargas
5
Likes
0
Makes
Turned the Lacrosse Head into a Trophy.
Printed the base at 0.3mm No Supports and the head at 0.2mm, tilted backwards about 15 degrees using tree supports for best results
There's an inset in front where you can add an engraved "plaque" (I did mine out of 1/8 acrylic on my laser, but with the right font and size you could print it too).
you can add text to the top (as shown)
Printed the base at 0.3mm No Supports and the head at 0.2mm, tilted backwards about 15 degrees using tree supports for best results
There's an inset in front where you can add an engraved "plaque" (I did mine out of 1/8 acrylic on my laser, but with the right font and size you could print it too).
you can add text to the top (as shown)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
