Thingiverse
Lacrosse Trophy
by rianocerous
2
Downloads
5
Likes
0
Makes
Turned the Lacrosse Head into a Trophy.
Printed the base at 0.3mm No Supports and the head at 0.2mm, tilted backwards about 15 degrees using tree supports for best results
There's an inset in front where you can add an engraved "plaque" (I did mine out of 1/8 acrylic on my laser, but with the right font and size you could print it too).
you can add text to the top (as shown)
Printed the base at 0.3mm No Supports and the head at 0.2mm, tilted backwards about 15 degrees using tree supports for best results
There's an inset in front where you can add an engraved "plaque" (I did mine out of 1/8 acrylic on my laser, but with the right font and size you could print it too).
you can add text to the top (as shown)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
