Thingiverse
Laing D5 pump bracket
von Jayyzz
5
Downloads
2
Likes
0
Makes
A bracket to hold up my D5 pump. Measured to be 93 mm high from bottom of the case to the bottom of the top on my D5 top. Makes use of a construction system, because my loop is already assembled, and one of the tubes goes under my D5 pump.
Don't forget to print the "side" 2 times!
Don't forget to print the "side" 2 times!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
