MakerWorld
Office
Model downloaden
Laptop and Tablet stand
28
Downloads
5
Likes
18
Makes
I made this Laptop and tablet stand/holder to reorganized my desk. It has 4 racks for holding Laptop/tablet up to 2 cm thick. From left to right is Macbook Pro 2015, Macbook Air with case, and 2 iPads. It is recommend to place from the back to the front to avoid flip over due to high center of gravity. The recommend infill is 10% to ensure the best top layer quality. You can use 5% infill to reduce print time and filament but it can cause defects on the top surface, use it at your own risk.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
