Thingiverse
Large M6, M8 Clamp Knobs
von stampydriver
20
Downloads
7
Likes
0
Makes
Clamp knobs in both M6 and M8 sizes. Designed to print without supports, I am successful in printing these in PLA without supports on a Creality CR10 printer.
These knobs are large with an outside diameter of 48mm.
Updated: Added an 8mm version where the nut cavity is 1mm smaller. This just fits the nuts I have, but have to tap them in with a small hammer.
These knobs are large with an outside diameter of 48mm.
Updated: Added an 8mm version where the nut cavity is 1mm smaller. This just fits the nuts I have, but have to tap them in with a small hammer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
