Thingiverse
Large Simple Filament Stand Side Frames
5
Downloads
3
Likes
0
Makes
Filament Stand Side Frames, suitable for an extended bolt like "The One - Anet A8 - Universal Spool Holder".
see https://www.thingiverse.com/thing:4927408 for a suitable nut and bolt.
Additional hardware for assembly:
* 2 - 4 lengths of M10 threaded rod of suitable length (225mm lengths in my case).
* A slightly shorter M8 rod for the bolt (210mm in my case).
* 2 x 608ZZ 2mm bearings.
* For each M8 & M10 rod, 4 x hex nuts and washers.
I've made bosses for 4 rods, but two are probably sufficient. I used 3 because I'd already cut the third one.
see https://www.thingiverse.com/thing:4927408 for a suitable nut and bolt.
Additional hardware for assembly:
* 2 - 4 lengths of M10 threaded rod of suitable length (225mm lengths in my case).
* A slightly shorter M8 rod for the bolt (210mm in my case).
* 2 x 608ZZ 2mm bearings.
* For each M8 & M10 rod, 4 x hex nuts and washers.
I've made bosses for 4 rods, but two are probably sufficient. I used 3 because I'd already cut the third one.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!