Laser cut Hex based Tabletop riser

Laser cutter base table top riser. designed initially for Battletech mech scale but supports any 32mm hex base units (32mm is flat to flat hex size)

Due to the way they slot together there are more tiles types than you might think
9 Different tiles - each with 3 dxfs.
4 corners, 4 sides and a middle piece = 9

Each tile has an upper and lower sheet of wood. They slot together with neighboring tiles at a hex boundary with holes for 6mm diameter magnets (3mm deep assuming you use 3mm wood) so they snap together

Lower also has M5 nut holes to glue a nut there for M5 thread bar as legs

Each tile is approx 25cm x 25cm (max size I could easily fit upper and lower piece on a single 600x400mm wood sheet)

Minimum 4 tiles needed for basic 2x2 square which will require one of each corner.
Identical Corners will not slot together!

Tile naming
- Corner
- - BL = bottom left
- - BR = bottom right
- - TL = top left
- - TR = top right
- Side
- - SL = left side
- - SR