Thingiverse
Latch Test
von jathon
0
Downloads
0
Likes
0
Makes
Just a simple model to test the strength and suitability of different thicknesses of a material for a latch.
Didn't use supports but overhang on the latch required the hole in the tester to be a slightly enlarged.
Didn't use supports but overhang on the latch required the hole in the tester to be a slightly enlarged.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!