Thingiverse
Launch Controller Model Rocket
por Owen1975
49
Descargas
39
Likes
0
Makes
Launchcontroller for model Rockets. I used an old LiPo 11.1 Volt battery.
Printed from PLA.
For the topcover I printed in 0.2 mm until the 7mm hight. Than put a filament change in and finish the last 1.5 mm in 0.15 mm layerhight.
This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/dm3MEHENG4k
https://www.tinkercad.com/things/9u9VlmDTWoL
Printed from PLA.
For the topcover I printed in 0.2 mm until the 7mm hight. Than put a filament change in and finish the last 1.5 mm in 0.15 mm layerhight.
This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/dm3MEHENG4k
https://www.tinkercad.com/things/9u9VlmDTWoL
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!