Thingiverse
Layer Test X
door SteveSchulz
3
Downloads
0
Likes
0
Makes
When printed, drag your finger across each square. They should feel smooth and ripply. If they are rough adjust that corner down because the nozzle is too close. If it is lifted or stringy then adjust that corner up because the nozzle is too far away.
After adjusting, print again. Keep repeating until they are as perfect as you desire.
After adjusting, print again. Keep repeating until they are as perfect as you desire.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!