Thingiverse
LCD Controller Case
60
Download
53
Likes
0
Makes
This was designed for the purpose of housing an LCD controller/logic board. These are used to control a stand-alone LCD screen. In my case, I salvaged the LCD panel from an old laptop and bought the controller board through amazon.You can find them easily online wherever you're at.
This houses the controller itself, not the actual LCD. JUST THE BOARD. LCD casings will come in due time. I noticed a need, attempting to fill it.
Has not been tested as of 5/10/18. Freshly Uploaded.
Potential Changes. Hole Dia is currently at 1mm. Rather than use screws, i was going more for an adhesive/filler to join the top to the bottom.
Should print fine at 0.25-0.35mm layer height
Use at least 2x nozzle size for wall thickness in CURA (2-3 layers in S3D), 3x (if using 0.4mm Nozzle, wall thickness would be at least 0.8mm if not 1.2mm recommended. All wall thicknesses are at 3mm.
Supports may be needed for IO cutouts (HDMI hole/Power Hole/DVI Hole/etc)
Cheers!
Feel free to leave
This houses the controller itself, not the actual LCD. JUST THE BOARD. LCD casings will come in due time. I noticed a need, attempting to fill it.
Has not been tested as of 5/10/18. Freshly Uploaded.
Potential Changes. Hole Dia is currently at 1mm. Rather than use screws, i was going more for an adhesive/filler to join the top to the bottom.
Should print fine at 0.25-0.35mm layer height
Use at least 2x nozzle size for wall thickness in CURA (2-3 layers in S3D), 3x (if using 0.4mm Nozzle, wall thickness would be at least 0.8mm if not 1.2mm recommended. All wall thicknesses are at 3mm.
Supports may be needed for IO cutouts (HDMI hole/Power Hole/DVI Hole/etc)
Cheers!
Feel free to leave
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
