Thingiverse
LED Light Tower (Variable Height)
von mike5287
86
Downloads
90
Likes
1
Makes
This is very much a work in progress - you can print it and it should work out fine - just a few things need to be tweaked to make things easier (see below). Also - the 2 pieces shown in the pictures are not the actual length - those were shorter sections I did to make it easier to test things as I went along.
This is an LED light tower that has been made so you can control how tall the tower is by printing out more lengths of tower:
- Long is for 300mm or larger bed sizes
- Short is for 220mm bed size
I downloaded an LED tower and found that it was basically just a simple "U" with a base - the LED lights had to be stuck on the side of the "U" channel - wasn't what I wanted so my design has two channels - one for the light strip and one for a diffuser (printed in white). There is a base, tower, and tower top pieces all with male/female connectors. You can print as many of the "tower" pieces as you want to vary the height.
I started with a design that glued together, but th
This is an LED light tower that has been made so you can control how tall the tower is by printing out more lengths of tower:
- Long is for 300mm or larger bed sizes
- Short is for 220mm bed size
I downloaded an LED tower and found that it was basically just a simple "U" with a base - the LED lights had to be stuck on the side of the "U" channel - wasn't what I wanted so my design has two channels - one for the light strip and one for a diffuser (printed in white). There is a base, tower, and tower top pieces all with male/female connectors. You can print as many of the "tower" pieces as you want to vary the height.
I started with a design that glued together, but th
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
