LED Tester Enclosure

Sorry for the bad print. Was in a rush to get this in something and printed quickly at .3 layer thickness.

Enclosure for a very handy LED tester/polarity check.

How to make here: http://www.electronics-lab.com/project/simple-smd-led-tester/

BOM:
You can have your PCB's made at Seeed Studio Bazaar with the Gerber file from the site above. Roughly $10 for 10 boards + shipping. http://www.seeedstudio.com/service/index.php?r=site/PremiumPcb

Battery holder - http://www.mouser.com/Search/ProductDetail.aspx?R=S8421-45Rvirtualkey57420000virtualkey855-S8421-45R

Used 2 x 6mm self tapping screws for the lid.
Tact Switch - http://www.mouser.com/Search/ProductDetail.aspx?R=1571563-1virtualkey50660000virtualkey506-1571563-1

Thick Film Resistors - SMD 68ohm 5% - http://www.mouser.com/Search/ProductDetail.aspx?R=CR0805-JW-680ELFvirtualkey65210000virtualkey652-CR0805JW-680ELF

0805 SMD LED - http://lighthouseleds.com/led-component-lighting/smd-leds-surface-mount-diodes/0805-s