Thingiverse
Lemon Case
von Zomon333
1
Downloads
2
Likes
0
Makes
This lemon has been separated into two hollow halves for printing, so you may store things in your lemon.
I recommend adding four 6mm magnets to the piece so it stays closed. Holes for these have been added. You will need to scale your model to fit these.
I recommend adding four 6mm magnets to the piece so it stays closed. Holes for these have been added. You will need to scale your model to fit these.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
