Thingiverse
Level Gcode with FIXED PAUSE
von LachyD5959
9
Downloads
3
Likes
0
Makes
IGNORE THE STL --- JUST USE THE .GCODE
This is a Gcode levelling program for the Ender 3/Pro. This is a remix, as I found many programs however none of them actually paused my printer.
If you haven't already tried the original, I would suggest doing that, however, if you have tried the original look no further than this.
Just load it up and hit start, it will pause at each location twice.
This is a Gcode levelling program for the Ender 3/Pro. This is a remix, as I found many programs however none of them actually paused my printer.
If you haven't already tried the original, I would suggest doing that, however, if you have tried the original look no further than this.
Just load it up and hit start, it will pause at each location twice.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!