Thingiverse
Level Test
von eltravieso
2
Downloads
0
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/lQlKu4CnD8j
I use this to level my bed. While it prints I level the bed until I get a good layer happening. If too thin I tighten the nob. If not adhearing then I loosen the nob
Printed at .2mm resolution.
No Brim or Skirt
I use this to level my bed. While it prints I level the bed until I get a good layer happening. If too thin I tighten the nob. If not adhearing then I loosen the nob
Printed at .2mm resolution.
No Brim or Skirt
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
