Thingiverse
leveling ring for micromake debugger.
door candyasdf
30
Downloads
12
Likes
0
Makes
fast printing 7 ring for leveling test.
set you layer height under 0.25, go to debugger tab>parameter.
all the ring are 0.5mm thick. you can adjust the XYZ axis limit switch separately. the center circle is for set up horizontal radius. and distance of the cross mark in circle are 6cm. that is scale tuning for Rod Length.
set you layer height under 0.25, go to debugger tab>parameter.
all the ring are 0.5mm thick. you can adjust the XYZ axis limit switch separately. the center circle is for set up horizontal radius. and distance of the cross mark in circle are 6cm. that is scale tuning for Rod Length.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!