Thingiverse
Light bracket
door xianic
1
Downloads
0
Likes
0
Makes
This bracket allows attaching an LED light bar to the to the 20mm box section frame of my 3D printer using M5 bolts. The mounting holes on the original are a bit too small.
Prepare the light bar by removing the original mounting holes with a pair of side cutters and peal the double sided tape off the back. The ends of the bar will then slide into the bracket.
The lighting bar is available from [Hobbytronics](http://www.hobbytronics.co.uk/led-light-bar) (UK), and [Sparkfun](https://www.sparkfun.com/products/12014) (US). The image of the lighting bar was provided by Sparkfun.
Prepare the light bar by removing the original mounting holes with a pair of side cutters and peal the double sided tape off the back. The ends of the bar will then slide into the bracket.
The lighting bar is available from [Hobbytronics](http://www.hobbytronics.co.uk/led-light-bar) (UK), and [Sparkfun](https://www.sparkfun.com/products/12014) (US). The image of the lighting bar was provided by Sparkfun.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!