Thingiverse
Light Pull
von GSMArtFPV
6
Downloads
2
Likes
0
Makes
pring bulb part with the joint on the bed, you may want to put a brim. no support
print the threaded section, small end down, you will need support, touching buildplate only
string goes through threaded part which then screws into the bulb
(see screenshots fo print orientation)
print the threaded section, small end down, you will need support, touching buildplate only
string goes through threaded part which then screws into the bulb
(see screenshots fo print orientation)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
