Thingiverse
Light system
door mcthon
7
Downloads
5
Likes
0
Makes
This is a system to use 1" X 3/4" aluminium u bar to use it as a led fixture.
If you print only the "Embout limiere pit" you can run the wire through hole and solder it to you led strip. The other side will be plug with the 201604200821 PLug Embout limiere pit.stl.
After you mount your wire and your led you can poor epoxy (without uv protector to keep it clear) in the rail to protet it from outside element.
The support is provide if you intend to put two rail for up and down ligthning.
If you print only the "Embout limiere pit" you can run the wire through hole and solder it to you led strip. The other side will be plug with the 201604200821 PLug Embout limiere pit.stl.
After you mount your wire and your led you can poor epoxy (without uv protector to keep it clear) in the rail to protet it from outside element.
The support is provide if you intend to put two rail for up and down ligthning.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!