light webcam mic modular desk mount

Just my design of modular desk mount for light, webcam or microphone.

Use 5 pieces of 8mm diameter rods (aluminum, or plastic, or whatever fits better to you).
The length is not critical, but don't go very long. The 3 vertical rods should be identical in length. The same needed for the two horizontal.

In my case I use everywhere 450mm and its quite stable. If you need to use different diameter rods, send me a message to make 'join' part fitted to your diameter.

Print 'join' part 10 times to connect rods. If needed, use a proper glue to fix 'join' parts on rods. Consider orientation of the parts before glue.

One more time is needed for final piece you will have at the end of the structure. Maybe you can design a different part.

Print 'knee' part 4 times, use 2 in each knee as shown in photos.

Use 'separator-A' part between ankle-L and ankle-R parts (image 8)
Use 'separator-B' (print 2 pieces - image 12)

Use a 51105 thrust ball bearing 25x42x11mm between 'rotato