Lighted Tactile Button

This is a small momentary button about 26mm square with space for a single addressable LED. All three pieces print in approximately one hour.


Print button with flange facing the build plate, I used support and left it in there. Original plan was to embed the light strip in the button but it distributes light just fine this way.

Button Body printed upside down no support needed

Button base no support needed should fit together with slight friction fit. Glue may still be needed.

In my suggested layout you will see two tactile buttons approximately 6x6x5 (lwh) electronically two is not needed but I liked the way they click and these switches are cheap. In the middle is a WS2812 led.