Linear Camera Slider

A great camera becomes even more useful with the right accessory. This fully 3D-printable camera slider is designed specifically for the Insta360 Luna Ultra and adds the missing 4th axis. It complements the Luna Ultra’s 3-axis camera system and keeps the setup compact and simple, without needing a large, heavy, or expensive slider. Combined with Luna Ultra’s object tracking, the camera can stay focused on a subject while the slider adds movement to the shot. The slider uses a manual drive system with adjustable speed. By changing the diameter of the drive shaft, you can choose between slower, more controlled movement or faster sliding motion depending on your shot. The design is modular, can be expanded or customized, and supports the use of a standard 1/4" mount. If you have any suggestions just write them in the comments. ASSEMBLY INSTRUCTIONS How long should the cord be? 1 track: 33cm / 13" 2 tracks: 68cm / 26,7" 3 tracks: 100cm / 39,4" 4 tracks: 135cm / 53.2" (These meassurements may vary but its a baseline) Parts on Plates: STEP 1: STEP 2: STEP 3: How to lay the cord How to tighten the cord