Lithobox

Thanks to Lapake for the base design. I used his to add a base and hole for my led light. Then I added the ability to put a photo on the top.

Side Photos are 80x80mm
Top Photo is 85x85mm

Printed in .2mm at 80mm/sec with 15% infill. Used supports under the base and the top. The hole in the bottom is 21mm wide. Wide enough to accept a standard right angle candelabra light socket from Amazon. I used a 5w LED bulb and it provides plenty of light and little heat.

This is a design in progress but overall I am very happy with the progress so far.