Lithopane lamp E14

Base: Can be printet without support. I chose to print with support just to be sure.
~13 hours

Rack: No support needed. Slide for lithopane is 4mm
~6 hours

Lid/top: This I printet with support laying down, just to make sure the edges were supported. You may want to increase infill on this one to 15 ish, to get a more pretty surface.
~3 hours

Above print is with printspeed 70mm/s

For added strength in the connection between the base and the rack, you can drop a bit of glue in the holes.

Feel free to ask any question. I will try to answer to the best of my knowledge