Little Cube Guy

Descripción Something quick, because of course I had to make an entry for the jointed figures competition! This snap-fit model starts as a one-inch cube and flips inside out to reveal a cute, spiderlike robot.   Instructions The 3MF file has all the parts laid out in one file, or you can print individual parts as desired. You'll need one cube body, two root joints, and four each of the legs and feet. Parts are designed to print without supports, but a brim can help with adhesion on the small parts. Recommended print settings MaterialPETG, ABS, or ASA for best results PLA is okay, but the ball joints will loosen over time. Layer height0.15mm (first layer 0.2mm)Infill10-20% rectilinearFirst layer speedSLOW - 25% of default (at least for small parts)SupportsNoneBrimAs needed - small parts only A brim may interfere with the print-in-place hinges of the cube body. Additional settings✅ Print external perimeters first Once the parts are printed, assemble them as shown in the video below. All parts should snap-fit into place, no glue needed. This video also shows how to pack Little Cube Guy into its cube form, then transform it into spider form.   This design is now under a CC BY 4.0 license. This means that you are free to share these files however you like, including selling prints, provided that you give proper attribution. You can give proper attribution by including this notice on your product page: Little Cube Guy © 2023 by Lucky 13 Toys is licensed under CC BY 4.0 Please help me build my identity as a creator by referring to this design by its original name. Don't pass off my work as your own product. If this free model brought you joy (or profit), consider making a donation: PayPal | Stripe | Buy Me a Coffee