Thingiverse
Locksport Picking Vise
von WestCoastPicks
164
Downloads
105
Likes
5
Makes
This is a 3D printed vise made specifically for locksport though I'm sure it will have several other uses.
It requires a few parts, though nothing hard to find. 1/4 inch Rod for the stays, a 6 - 7 inch 5/16 carriage bolt with a nut to match and a washer. Also for the base you will need a 1 1/2 inch 1/4 inch bolt with a washer and a wingnut.
More info, hardware required and vise build seen here:
https://www.youtube.com/watch?v=jxvOhe5PmAo
10/20/18: Updated to vise 2.0 Newer design, bigger and stronger.
10/21/18: Added pickvise-base2 to files. A base with pinning slots, and a few dimples on the inner surface of the clamp to perhaps increase the bite when clamped.
10/21/18: Added pickvise-knob2 to files. A Larger knob for the vise for those who might have trouble using the smaller knob.
It requires a few parts, though nothing hard to find. 1/4 inch Rod for the stays, a 6 - 7 inch 5/16 carriage bolt with a nut to match and a washer. Also for the base you will need a 1 1/2 inch 1/4 inch bolt with a washer and a wingnut.
More info, hardware required and vise build seen here:
https://www.youtube.com/watch?v=jxvOhe5PmAo
10/20/18: Updated to vise 2.0 Newer design, bigger and stronger.
10/21/18: Added pickvise-base2 to files. A base with pinning slots, and a few dimples on the inner surface of the clamp to perhaps increase the bite when clamped.
10/21/18: Added pickvise-knob2 to files. A Larger knob for the vise for those who might have trouble using the smaller knob.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
