Thingiverse
Logitech MX Keys - Risers
door doesntfearzeus
46
Downloads
33
Likes
1
Makes
Just got myself the Logitech MX Keys, it's a great keyboard, but very low profile. Immediately began planning a riser that fits on the rear bar and lifts the back of the keyboard up to give what I feel is a more natural typing angle.
The bottom is rounded like the original base to give it flexibility for angle. You might want to add some grip if you use this on a smooth surface where it might let the keyboard slide.
Made it in 3 heights since I know everybody has they preferences. I printed SM and MD and found MD was my preference. I think LG would be too much for me without also finding a way to lift the front up a bit.
The pieces are measured to fit without any danger or forcing or scratching. You will likely need to add a little bit of tape (masking tape might be best, its what I used as shown) to the inside of this to get it to be a tight fit that lets you lift the keyboard and not have them fall off.
The bottom is rounded like the original base to give it flexibility for angle. You might want to add some grip if you use this on a smooth surface where it might let the keyboard slide.
Made it in 3 heights since I know everybody has they preferences. I printed SM and MD and found MD was my preference. I think LG would be too much for me without also finding a way to lift the front up a bit.
The pieces are measured to fit without any danger or forcing or scratching. You will likely need to add a little bit of tape (masking tape might be best, its what I used as shown) to the inside of this to get it to be a tight fit that lets you lift the keyboard and not have them fall off.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
