Thingiverse
Jewelry
Zum Modell
Lucha Libre Dusters
3
Downloads
4
Likes
0
Makes
A friend of mine is having a Luchador themed birthday bar crawl, along with the mask and cape i have ordered, I figured these rings would go well with my costume. I am currently printing them and may have to make changes.
The rings are sized for someone with the following finger diameters
Index: 21mm
Middle: 21mm
Ring: 20mm
Pinkey: 18mm
I am printing this in 3DSolutech White PLA. No Raft, No Supports (__This was a mistake, you WILL need supports.__)
EDIT: the dot over the "i" was not connected to anything, and the middle finger needed to be 21.5mm, also, somme of the letters were not connected very well to the rings.
Version 2 now includes a platform for the letters, and the triangles that were between the rings and below the letters have been filled in for stability. The middle finger is now 21.5mm, and the dot over the "i" in "Libre" has been connected to the i's main body.
The rings are sized for someone with the following finger diameters
Index: 21mm
Middle: 21mm
Ring: 20mm
Pinkey: 18mm
I am printing this in 3DSolutech White PLA. No Raft, No Supports (__This was a mistake, you WILL need supports.__)
EDIT: the dot over the "i" was not connected to anything, and the middle finger needed to be 21.5mm, also, somme of the letters were not connected very well to the rings.
Version 2 now includes a platform for the letters, and the triangles that were between the rings and below the letters have been filled in for stability. The middle finger is now 21.5mm, and the dot over the "i" in "Libre" has been connected to the i's main body.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
