M5Stack face plate

PLEASE READ BEFORE PRINTING

M5Stack face plate.
M5Stack-facev14.stl: Height does not match official face plate.
You can see on photo height is 2.1mm lower.

Please note: Regular proto board fits but requires removal of 8 pins. (top & bottom)
Also the connector is offset by 2.54mm so that only half the pins are connected through connector. A designed PCB is required for full compatibility.
If using the STD proto board the holes for fixing the PCB to the base are also in wrong place. You can see all this in the pictures.

The holes for the M3 bolts copper inserts are slightly too small. You need too much force to fit them easily. I used M3x5x4 from here https://a.aliexpress.com/AJNEFjo59

The text "M5STACK" does not come out as on the STL file.
The v14 test print was made on an Ultimaker S5 with 20% infill and 100μm layer.

I have tried to correct the height, hole size and text depth in an attempt to fix these issues.
This is the M5Stack-facev15.STL file.

PLEASE NO