Thingiverse
Macbook Stand
von DaBeast725
12
Downloads
13
Likes
0
Makes
This is a stand for MacBooks. The total height is 95mm tall. (the basic height of a monitor frame) This model is designed to fit both the 13 inch MacBook models as well as the 15 inch models. I made this so that my MacBook's screen will match up with my monitor I use for a second screen. Enjoy the model! I will post more photos once my print finishes.
RIGHT AND SUPPORTS FILES HAVE BEEN REVISED. ERRORS WERE FOUND AND CORRECTED.
ASSEMBLY: (refer to image for further clarification)
1) Print all three files.
2) The left and right side files will print two pieces. They slide together and require superglue. They should form a triangle.
3) The supports file has two perfectly square rectangular prisms. These prisms need to be glued on either side of the smallest part. (not the long sides of this part.).
4) Also printed in the Supports file is two fork like parts and two prisms with slants on one end. The fork like part and a prism with the slant connect together. These par
RIGHT AND SUPPORTS FILES HAVE BEEN REVISED. ERRORS WERE FOUND AND CORRECTED.
ASSEMBLY: (refer to image for further clarification)
1) Print all three files.
2) The left and right side files will print two pieces. They slide together and require superglue. They should form a triangle.
3) The supports file has two perfectly square rectangular prisms. These prisms need to be glued on either side of the smallest part. (not the long sides of this part.).
4) Also printed in the Supports file is two fork like parts and two prisms with slants on one end. The fork like part and a prism with the slant connect together. These par
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
