Marshmallow table

- - -
Would you like to support my work? :)
**Check out my [full catalogue](https://wonderl.ink/@gazzaladra) with exclusives, early access and commercial licenses.**
- - -

**A fully 3d printed marshmallow inspired coffee table**

Single and multi-color printing models are included as STL and 3MF! They work with all current and usual multi color setups.

Height: 50 cm
Width: 40 cm

**Instructions**
All parts are intended to be glued together! While the glue dries it makes sense to add a little duct tape to keep the parts together under pressure. Remove the tape after the glue dried.

- Print all parts
- Connect the three center pieces with the primary and secondary connectors
- Add the leg connectors and legs
- Assembly the top separately with the top connectors.
- Add the finished plate to the center

I tested the assembly extensively and I can say that this design managed to support 80 KG when printed in normal PLA. These are my own personal results, and I do