Material stock guide

Stock guide for router or table saw.
Consisting of 3 3D-printed parts and a few bits of hardware, this is a budget friendly system inspired by Jessems clear cut system.
The wheel has grooves for two O-rings for better grip. (OD: 38, ID: 30)
It is angled 5 degrees so that the stock is continously pushe towards the fence, and to avoid kickback it uses a CSK10 bearing (sprag clutch / one way bearing).
The spring in this system is in the arm between the rod and the wheel itselt.
If a weaker spring is needed after printing - just drill some holes through the parallel bits to weaken it.

All models are available for download on grabcad: https://grabcad.com/library/stock-guide-for-router-og-table-saw-1

Design is only for personal use, and may not be used commersially without permission.

Kind Regards
Anders