Thingiverse
Mechanical clock
von horogatya
12
Downloads
8
Likes
0
Makes
It's based on this thing:
https://www.thingiverse.com/thing:2381829
but I don't needed the seconds so I remixed it.
When I tested the stepper motor everything looks OK, but when I tested the clock that didn't turns enough, So I put a microswitch as a position sensor inside of the minutes wheel.
And the 3D printed pin for the minutes wheel was to small so I put there a screw.
For axle i used 8mm diameter metal pipe.
Later I wanna make a box for electronics.
https://www.thingiverse.com/thing:2381829
but I don't needed the seconds so I remixed it.
When I tested the stepper motor everything looks OK, but when I tested the clock that didn't turns enough, So I put a microswitch as a position sensor inside of the minutes wheel.
And the 3D printed pin for the minutes wheel was to small so I put there a screw.
For axle i used 8mm diameter metal pipe.
Later I wanna make a box for electronics.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!