Thingiverse
Mesh Deck
von dbuckl
0
Downloads
0
Likes
0
Makes
Printed with Elegoo CF PLA
Layer height - .2mm
Perimeters/Walls - 2
Infill - 15%
Also need 4 -3mmx12mm screws
Supports were used on the case
REVISION: Added clearance for the nRF52840 on the top.stl
Please post a picture if you make it
Layer height - .2mm
Perimeters/Walls - 2
Infill - 15%
Also need 4 -3mmx12mm screws
Supports were used on the case
REVISION: Added clearance for the nRF52840 on the top.stl
Please post a picture if you make it
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!