Thingiverse
Mic capsule pop filter bracket
1
Downloads
0
Likes
0
Makes
Designed for Audio Technica ATM650 (approx 28mm capsule housing), but will of course fit similar capsules.
The foam on my 10+ year old mic was all crumbly, so I cut some memory foam from [insert furniture] and needed a bracket to hold the foam in place so it didn't get all crumpled up while screwing in the mic's grill.
USE THIN FOAM or a mesh/sonically transparent fabric if you do this, otherwise your higher frequencies will be very muffled.
The foam on my 10+ year old mic was all crumbly, so I cut some memory foam from [insert furniture] and needed a bracket to hold the foam in place so it didn't get all crumpled up while screwing in the mic's grill.
USE THIN FOAM or a mesh/sonically transparent fabric if you do this, otherwise your higher frequencies will be very muffled.
666tonsofsquirrels veröffentlicht auch auf
33 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
