Mickey

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change the X and Y but Z can remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 4.6mm Filaments Used: PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic White Transmission Distance: 5 This print uses 4 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #17 (1.44mm) swap to Red At layer #21 (1.76mm) swap to Black At layer #29 (2.4mm) swap to Beige At layer #47 (3.84mm) swap to White for the rest.