Thingiverse
Micro Bit remix
por cummingst
1
Descargas
1
Likes
0
Makes
I remixed the Robottillo:bit that I found on Thingiverse. https://www.thingiverse.com/thing:2573930
I modified to remove the T on the back cover instead i put command strip Velcro. This was due to the speaker being added to V2 of the MicroBot.
I also cut out part of the front cover so I can have access to the additional sensor on the front.
I would suggest getting small metal bolts (5) so you can use alligator clips to still use the access point to additional features.
The back cover is a little large if you want to tighten it print at 95.5%
No support needed
I modified to remove the T on the back cover instead i put command strip Velcro. This was due to the speaker being added to V2 of the MicroBot.
I also cut out part of the front cover so I can have access to the additional sensor on the front.
I would suggest getting small metal bolts (5) so you can use alligator clips to still use the access point to additional features.
The back cover is a little large if you want to tighten it print at 95.5%
No support needed
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
